D019 | S306 | No case number · email dated 2024-10-11

Mechanical extraction of the PDF’s existing text layer. No OCR performed. Reading order, stamps, handwriting, tables and symbols may be incomplete or inaccurate. Compare quotations with the unchanged original PDF; PDF page numbers refer to file pages, not necessarily printed page labels. Extraction is not court authentication or legal verification. Personal phone numbers and direct email addresses are redacted from this public derivative; the protected original is unchanged. The email records sender-reported concerns, not findings.

PDF page 1 — text-layer available
From: Jim Kurtz <[DIRECT EMAIL REDACTED]>
Sent: Friday, October 11, 2024 3:05:40 PM
To: Victor Jiang <[DIRECT EMAIL REDACTED]>
Cc: Terri Fodchuk <[DIRECT EMAIL REDACTED]>; Michel Rheaume <[DIRECT EMAIL REDACTED]>
Subject: MFG date
Good afternoon Victor
There is something that has come to my attention and I need to express my concern. When
some of the scissors and booms arrived this year, Dan was asked to change the serial
plates to represent the manufacture date from 2023 to 20241 expressed concern about
this but didn't push to hard, now yesterday I was told that the updated 4047DC units from
Can lift that are now CSA certified are getting new serial plates with a manufacturing date
of 2024 but the units are actually ranging from 2020 to 2022 manufacturing years. This is of
great concern as, if there was ever an accident and it was investigated XCMG Canada as
well as management that were aware of this could face grave consequences. In Canada
scissors and booms have to be NOT tested after the initial ten years and then every five
years after. Since these units are already between two and four years old the NOT
requirements will be greatly affected.
Thanks
Jim
Solid to Succeed
Jbnl(urtz
Director of Service
XCMG Canada Ltd.
Address: 100 Burland Cresent, Hamilton, ON
Hotline: 855-789-XCMG
Office: [PERSONAL PHONE REDACTED]
Cell:[PERSONAL PHONE REDACTED]
Email:[DIRECT EMAIL REDACTED]
rilXC'MG
,,.
r'
2